Display day/night mode does not work or does not work properly
NOTE:
- Check the vehicle battery condition first (see BATTERY TEST ).
- Check the connectors for poor connection or loose terminals.
- Check any official Honda service website for more service information about the navigation system.
- Before troubleshooting, make sure you have the navigation system anti-theft code.
- After troubleshooting, enter the navigation system anti-theft code.
- Full brightness on the instrument panel brightness control with the head lights turned on causes the system to stay in the day mode, even when the lights are on.
- Make sure the instrument panel brightness control is not on full brightness. Turn the headlights on and adjust the dash brightness to the middle range.
- Change the day/night mode under Set-up to AUTO and recheck.
Does the display change to day and night modes when turning the headlights on and off?
YES -The system is OK at this time. ■
NO -Go to step 3.
- Go into the System Diagnostic Mode, and use the CAR STATUS TEST to check for an ILL signal
.
Is the ILL signal OK?
YES -Replace the AUDIO-NAVIGATION UNIT . ■
NO -Check the ILL+ circuit between the audio-navigation unit and the No. 2 (15 A) fuse in the under-hood fuse/relay box. ■