LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2007 >> Pilot EX, 3.5 YF1 >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating/Air Conditioning >> Front Power Transistor Test

Front Power Transistor Test

  1. Disconnect the 5P connector from the power transistor.
  2. Measure the resistance between the No. 1 and No. 4 terminals of the power transistor. It should be about 1.4-1.5 kΩ.
    • If the resistance is within the specifications, go to step  3.
    • If the resistance is not within the specifications, replace the power transistor.
      Fig 1: Checking Resistance Between No. 1 & No. 4 Terminals Of Power Transistor
      G04246862Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Carefully release the lock tab on the No. 3 terminal (ORN/BLK) (A) in the 5P connector, then remove the terminal and insulate it from body ground.
    Fig 2: Removing Terminal (ORN/BLK)
    G04246863Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Reconnect the 5P connector to the power transistor.
  5. Supply 12 V to the No. 3 cavity with a jumper wire.
  6. Turn the ignition switch ON (II), and check that the blower motor runs.
    • If the blower motor does not run, replace the power transistor.
    • If the blower motor runs, the power transistor is OK.