LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2007 >> Pilot EX, 3.5 YF1 >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating/Air Conditioning >> A/C Compressor Replacement

A/C Compressor Replacement

  1. If the A/C compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off.
  2. Make sure you have the anti-theft codes for the radio and the navigation system, then write down the audio presets.
  3. Disconnect the negative cable from the battery.
  4. Recover the refrigerant with a recovery/recycling/charging station (see REFRIGERANT RECOVERY  ).
  5. Remove the alternator (see TENSIONER PULLEY REPLACEMENT ).
  6. Remove the bolts from the cooler line brackets (A).
    Fig 1: Removing Bolts From Cooler Line Brackets With Torque Specifications
    G04246888Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Remove the A/C compressor clutch harness clip (A) from the A/C condenser fan shroud (B), then disconnect the connector. Disconnect the A/C condenser fan connector (C), then remove the wire harness clips (D) from the A/C condenser fan shroud. Loosen the lower mounting bolts, then remove the upper mounting bolts and the A/C condenser fan shroud. Be careful not to damage the radiator fins when removing the A/C condenser fan shroud.
    Fig 2: Disconnecting A/C Condenser Fan Connector With Torque Specifications
    G04246889Courtesy of AMERICAN HONDA MOTOR CO., INC.
  8. Disconnect the A/C compressor clutch connector (A) remove the bolt and the nut, then disconnect the suction line (B) and discharge line (C) from the A/C compressor. Plug or cap the lines immediately after disconnecting them to avoid moisture and dust contamination.
    Fig 3: Disconnecting Suction Line And Discharge Line From A/C Compressor With Torque Specifications
    G04246890Courtesy of AMERICAN HONDA MOTOR CO., INC.
  9. Remove the mounting bolts and the A/C compressor. Be careful not to damage the radiator fins when removing the A/C compressor.
    Fig 4: Removing A/C Compressor And Mounting Bolts With Torque Specifications
    G04246891Courtesy of AMERICAN HONDA MOTOR CO., INC.
  10. Install the A/C compressor in the reverse order of removal, and note these items:
    • If you're installing a new A/C compressor, you must calculate the amount of refrigerant oil to be removed from it (see A/C SERVICE TIPS AND PRECAUTIONS  ).
    • Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the correct O-rings for HFC-134a (R-134a) to avoid leakage.
    • Use refrigerant oil (DENSO ND-OIL 8) for HFC-134a DENSO piston type A/C compressor only.
    • To avoid contamination, do not return the oil to the container once dispensed, and never mix it with other refrigerant oils.
    • Immediately after using the oil, reinstall the cap on the container, and seal it to avoid moisture absorption.
    • Do not spill the refrigerant oil on the vehicle; it may damage the paint; if the refrigerant oil contacts the paint, wash it off immediately.
    • Be careful not to damage the radiator fins when installing the A/C compressor or the A/C condenser fan shroud.
    • Charge the system (see SYSTEM CHARGING  ).
    • Reset the power window control unit (see RESETTING THE POWER WINDOW CONTROL UNIT ).
    • Enter the anti-theft codes for the radio, and the navigation system then enter the audio presets.