LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2007 >> Pilot EX, 3.5 YF1 >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Engine Lubrication System >> Oil Pump Overhaul >> Installation

Oil Pump Overhaul: Installation

  1. Remove the old oil seal from the oil pump.
  2. Gently tap in the new oil seal until the oil seal driver bottoms on the pump.
    Fig 1: Tapping In New Oil Seal Gently
    G04244992Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove all of the old liquid gasket from the oil pump mating surfaces, bolts, and bolt holes.
  4. Clean and dry the oil pump mating surfaces.
  5. Apply liquid gasket, P/N 08717-0004, 08718-0001, 08718-0002, 08718-0003, or 08718-0009, evenly to the engine block mating surface of the oil pump.
    NOTE:
    • If you apply liquid gasket P/N 08718-0012, the component must be installed within 4 minutes.
    • If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply the new liquid gasket.
    NOTE: Do not install components if too much time has passed after applying the liquid gasket (for P/N 08718-0002, no more than 4 minutes, for all others, no more than 5 minutes). Instead, remove the old residue and reapply the liquid gasket.
    Fig 2: Applying Liquid Gasket To Engine Block Mating Surface
    G04244993Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Grease the lip of the oil seal, and apply oil to the new O-ring (A).
    Fig 3: Applying Oil To New O-Ring With Torque Specifications
    G04244994Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Install the dowel pins (B), then align the inner rotor with the crankshaft, and install the oil pump (C).
    NOTE:
    • Wait at least 30 minutes before filling the engine with oil.
    • Do not run the engine for at least 3 hours after installing the oil pump.
  8. Clean the excess grease off the crankshaft, and check the seal for distortion.
  9. Install the oil screen (D) with new O-ring (E).
  10. Install the rocker arm oil control solenoid/oil filter assembly (J35A9 engine) (see step 38 in CRANKSHAFT AND PISTON INSTALLATION ).
  11. Install the oil filter base/oil filter assembly (J35Z1 engine) (see step 39 in CRANKSHAFT AND PISTON INSTALLATION ).
  12. Install the oil pan (see OIL PAN INSTALLATION ).
  13. Install the crankshaft position (CKP) sensor (see CKP SENSOR REPLACEMENT ).
  14. Install the timing belt:
  15. Remove the chain hoist.