LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2007 >> Pilot EX, 3.5 YF1 >> Repair and Diagnosis >> Engine Mechanical >> Intake Manifold And Exhaust System >> Injector Base Removal and Installation >> Installation

Injector Base Removal and Installation: Installation

  1. Install the front injector base (A) and rear injector base (B) with new gaskets (C), and torque the bolts/nuts (D) in a crisscross pattern in three steps, beginning with the inner nuts.
    NOTE: The front injector base gasket is different from the rear one. Do not mix injector base gasket types.
  2. Fig 1: Installing Front Injector Base And Rear Injector Base With New Gaskets, And Torquing Bolts/Nuts In Crisscross Pattern
    G00465049Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Install the knock sensor connector (A) and harness bracket mount bolt (B).
  4. Fig 2: Installing Knock Sensor Connector And Harness Bracket Mount Bolt
    G00465050Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Install the injectors (see INJECTOR REPLACEMENT ).
  6. Install the intake mainfold (see Removal ).
  7. Install the P/S pump and P/S hose bracket (see 27 under CYLINDER HEAD INSTALLATION )
  8. Inspect for fuel leaks. Turn the ignition switch ON (II) (do not operate the starter) so the fuel pump runs about 2 seconds and pressurizes the fuel line. Repeat this operation three times, then check for fuel leakage at any point in the fuel line.