LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2007 >> Pilot EX, 3.5 YF1 >> Repair and Diagnosis >> Electrical >> Body Electrical >> Ac Power Outlet >> AC Inverter Unit Input Test

AC Inverter Unit Input Test

  1. Make sure you have the anti-theft codes for the radio and the navigation system, then write down the radio station and the XM channel presets. Make sure the ignition switch is OFF.
  2. Disconnect the negative battery cable.
  3. Remove the front passenger's seat (see FRONT SEAT REMOVAL/INSTALLATION ).
  4. Disconnect the 12P connector (A) from the AC inverter unit (B).
    Fig 1: Disconnecting 12P Connector From AC Inverter Unit
    G04247378Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Inspect the connector and socket terminals to be sure they are all making good contact.
    • If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
    • If the terminals look OK, go to step  5.
  6. With the control unit still disconnected, make these input tests at the connector.
    • If any test indicates a problem, find and correct the cause, then recheck the system.
    • If all the input tests prove OK, the control unit must be faulty; replace the control unit.
      TERMINALS REFERENCE CHART (AC INVERTER UNIT)

      Cavity Wire Test condition Test: Desired result Possible cause if result is not obtained
      5(1) BLK Under all conditions Check for voltage to ground: There should be less than 1 V.
      • Poor ground (G401)
      • An open in the wire
      1(1) GRN Under all conditions Check for voltage to ground: There should be battery voltage.
      • Blown No. 1 (20 A) fuse in the auxiliary under-hood fuse box
      • An open in the wire
      3(1) ORN Ignition switch ON (II) Check for voltage to ground: There should be battery voltage.
      • Blown No. 4 (7.5 A) fuse in the driver's under-dash fuse/relay box
      • Faulty driver's under-dash fuse/relay box
      • An open in the wire
      4 YEL Under all conditions Check for continuity between the No. 4 terminal and power outlet 3P connector No. 3 terminal: There should be continuity. An open in the wire
      11 WHT Under all conditions Check for continuity between the No. 11 terminal and power outlet 3P connector No. 1 terminal: There should be continuity. An open in the wire
      (1) Reconnect the connector to the AC inverter unit.