LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2007 >> Pilot EX, 3.5 YF1 >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Dashboard >> Driver's Switch Panel Removal/Installation

Driver's Switch Panel Removal/Installation

Special Tools Required 

KTC trim tool set SOJATP2014 *

* Available through the American Honda Tool and Equipment Program

NOTE:
  • Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
  • Take care not to scratch the dashboard and related parts.
  1. Remove the driver's switch panel (A).
    • - Using a flat-tip screwdriver, pry out the bottom portion of the panel to detach the clips.
    • - Pull out the panel to release the upper hooks (B), then remove the panel.
    • - Disconnect the cruise control main switch connector (C), and interior lights switch connector (D) and moon roof switch connector (E).
      Fig 1: Removing Driver's Switch Panel
      G04248258Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Install the panel in the reverse order of removal, and note these items:
    • Make sure each connector is plugged in properly.
    • Check for damaged or stress-whitened clips, and replace them with a new one.
    • Push the clips and hooks into place securely.