LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2007 >> Fit Base, Standard >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> FENDERWELL >> Front Inner Fender Replacement

Front Inner Fender Replacement

NOTE:
  • Put on gloves to protect your hands.
  • Take care not to scratch the body.
  1. Remove the front inner fender (A).
    1. On the back of the wheel arch, remove the screws (B)and clip (C), and remove the front splash guard (D) (Canadian model).
    2. From under the front bumper (E), remove the screw (F) securing the lower front bumper cover (G), front splash shield (H), and front inner fender, and remove the clip (I) securing the front bumper and front inner fender. With front air spoiler, remove the clip (J) securing the front air spoiler, front bumper, and front inner fender.
    3. From the wheel arch, remove the bolt (K) (left side) and clips (L, M, N) that secure the front inner fender (and splash shield) to the body.
    4. Release the hook (O) of the splash shield from the front inner fender, then pull the front inner fender out.
    NOTE: To remove the clips I and J, pry the inner pin up at the edge near the line (P) on its head.
    Fig 1: Identifying Front Inner Fender Fastener Locations
    G05456403
  2. Install the inner fender in the reverse order of removal, and note these items:
    • Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
    • Push the clips into place securely.