LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2007 >> Fit Base, Automatic >> Repair and Diagnosis >> Body & Frame >> Seats >> Front Seat Removal/Installation >> Driver's Seat

Driver's Seat

NOTE:
  • Put on gloves to protect your hands.
  • Take care not to scratch the body or tear the seat covers.
  • Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
  1. Make sure you have the anti-theft codes for the audio system.
  2. Disconnect the negative cable from the battery, then wait for 3 minutes before starting work.
  3. Remove the front inner seat track end cover (A) and front outer seat track end cover (B) from the front of both seat tracks.
    Fig 1: Removing Front Inner Seat Track End Cover And Front Outer Seat Track End Cover
    G05456294Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the rear inner seat track end cover (A) and rear outer seat track end cover (B) from the back of both seat tracks.
    Fig 2: Removing Rear Inner Seat Track End Cover And Rear Outer Seat Track End Cover
    G05456295Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Remove the bolts securing the front seat (A).
    Fig 3: Identifying Front Seat Bolts
    G05456296Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Lift up the front seat, then detach the harness clips (A), and disconnect the side airbag connector (B), the seat belt switch connector (C) and the seat position sensor connector (D).
    Fig 4: Identifying Side Airbag Connector, Seat Belt Switch Connector And Seat Position Sensor Connector
    G05456297Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Remove the head restraint.
  8. With the help of an assistant, carefully remove the front seat through the front door opening.
  9. Install the seat in the reverse order of removal, and note these items:
    • Apply medium strength type liquid thread lock to the seat mounting bolts before reinstallation.
    • Tighten the seat mounting bolts to the specified torque in the sequence shown. Slide the seat all the way back and tighten 1 and 2 then slide it forward and tighten 3 and 4.
    • Route the floor wire harness (A) between the seat cushion frame and the slide cable (B) before fixing its clips to the frame.
    • Make sure each connector is plugged in properly.
    • Tighten the bolts by hand first, then tighten them to specification with a torque wrench.
    • Reconnect the negative cable to the battery.
    • Enter the anti-theft codes for the audio system.
    • Set the clock.
    • Check for any DTCs that may have been set during repairs, and clear them.
    • Fig 5: Tightening Driver's Seat Bolts With Torque Specification
      G05456298Courtesy of AMERICAN HONDA MOTOR CO., INC.