LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2007 >> Civic Hybrid >> Repair and Diagnosis >> Engine Performance >> System >> Intake Air System (Hybrid) >> Throttle Body Removal/Installation

Throttle Body Removal/Installation

CAUTION: Do not insert your fingers into the installed throttle body when you turn the ignition switch ON (II) or while the ignition switch is ON (II). If you do, you will seriously injure your fingers if the throttle valve is activated.
NOTE: If you are replacing or cleaning the throttle body, start at step  1. If you are removing the throttle body, start at step  4.
  1. Connect the HDS to the DLC while the engine is stopped.
  2. Select the INSPECTION MENU on the HDS.
  3. Do the TP POSITION CHECK in the ETCS TEST.
  4. Turn the ignition switch OFF.
  5. Remove the cowl cover (see step 2 on COWL COVER REPLACEMENT ) and under-cowl panel (see step 4 on COWL COVER REPLACEMENT ).
  6. Remove the air cleaner (see AIR CLEANER REMOVAL/INSTALLATION  ), and the intake air duct (A).
    Fig 1: Identifying Throttle Body Replacement Components With Torque Specifications
    G05533425Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Disconnect the throttle body connector (B).
  8. Disconnect and plug the water bypass hoses (C) and vacuum hose (D).
  9. Remove the throttle body (E).
  10. Install the parts in the reverse order of removal with a new gasket (F).
    NOTE: