Throttle Position Sensor Signal Inspection
NOTE:
- This procedure is to inspect the abnormalities of the throttle position sensor full closed position.
- Other failures than full closed position will store a DTC, therefore the procedure to inspect them are not included in this procedure.
- Check for Temporary DTCs or DTCs with the HDS before this procedure. If there are any DTCs indicated, troubleshoot them first, then do this procedure.
- Press the accelerator pedal several times, and check the operation. If it does not operate properly check the accelerator pedal, the throttle cable, and the throttle linkage individually. If you find a problem in one of them, replace the parts that caused the problem.
- Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.
- Turn the ignition switch ON (II).
- Make sure the HDS communicates with the ECM/PCM. If it doesn't, go to the DLC circuit troubleshooting (see DLC CIRCUIT TROUBLESHOOTING ).
- Make sure the accelerator pedal is not pressed and check the TP SENSOR in the DATA LIST with the HDS.
- If it is below 0.5 V, the throttle position sensor is OK.
- If it is above 0.5 V, adjust the throttle cable (see Throttle Cable Adjustment ), then go to step 5.
- Make sure the accelerator pedal is not pressed and check the TP SENSOR in the DATA LIST with the HDS.
- If it is below 0.5 V, the throttle position sensor is OK.
- If it is above 0.5V, update the ECM/PCM if it does not have the latest software (see UPDATING THE ECM/PCM ), or substitute a known-good ECM/PCM (see SUBSTITUTE THE ECM/PCM ), then go to step 6. ).
- Make sure the accelerator pedal is not pressed and check the TP SENSOR in the DATA LIST with the HDS.
- If it is below 0.5V, the throttle position sensor is OK.
- If it is above 0.5V, replace the throttle body assembly (see 2003-2005 models ), then go to step 1.