LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2007 >> Accord Base, Standard, APG6 >> Repair and Diagnosis >> Body & Frame >> Windows >> Power Windows (Except Hybrid) >> Driver's Window Motor Test >> Motor Test

Motor Test

  1. Remove the driver's door panel.
  2. Disconnect the 6P connector (A) from the window motor.
    Fig 1: Disconnecting 6P Connector From Window Motor
    G03649109Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Test the motor in each direction by connecting battery power and ground according to the table shown below. When the motor stops running, disconnect one lead immediately.
    Fig 2: Connecting Battery Power And Ground Table
    G03649110Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. If the motor does not run or fails to run smoothly, replace it.

    Pulser Test 

  5. Reconnect the 6P connector to the window motor.
  6. Check for voltage between the terminals.
    • There should be battery voltage between the No. 6 (+) and No. 5 (-) terminals when the ignition switch is ON (II).
    • Connect an analog voltmeter between the No. 2 (+) and No. 5 (-) terminals, and run the window motor down or up. The voltmeter needle should move back and forth alternately (a digital voltmeter should show the average voltage between 0-5 V).
    • Connect an analog voltmeter between the No. 3 (+) and No. 5 (-) terminals, and run the window motor at down or up. The voltmeter needle should move back and forth alternately.

    If the voltage is not as specified, replace the driver's window motor.