DTC 83: Pcm
- Check the DTC.
Is DTC 86 indicated?
YES - Do the troubleshooting for DTC 86 (see DTC 86: F-CAN COMMUNICATION ).
NO - Go to step 2.
- Clear the DTC using the HDS (see HOW TO RETRIEVE DTCS ).
- Disconnect the HDS from the 16P DLC.
- Turn the ignition switch OFF, then turn it ON (II) again.
- Test-drive the vehicle.
Do the VSA and VSA activation indicators come on, and is DTC 83 indicated?
YES - Go to step 6.
NO - The system is OK at this time.
- Check the PGM-FI system.
Does the MIL indicator come on or is PCM's DTC indicated?
YES - Do the applicable troubleshooting for PCM.
NO - Go to step 7.
- Check the gear position.
Does the D indicator come on while N position is selected or is PCM's DTC indicated?
YES - Do the applicable troubleshooting for PCM.
NO - Check for loose terminals at the PCM connectors, and go to step 8.
- Clear the DTC using the HDS (see HOW TO RETRIEVE DTCS ).
- Turn the ignition switch OFF, then turn it ON (II) again.
- Test-drive the vehicle.
Is DTC 83 indicated and no PCM's DTC?
YES - Substitute a known-good PCM, and recheck. If the code returns, replace the VSA modulator-control unit (see VSA MODULATOR-CONTROL UNIT REMOVAL AND INSTALLATION ).
NO - The system is OK at this time.