LEMON Manuals: Even more car manuals for everyone

DTC 65: Brake Fluid Level

  1. Check the brake fluid level.

    Is the level correct? 

    YES  - Go to step 2.

    NO  - Check for leaks in the brake system. If no leaks are found, inspect the brake lining and replace any worn brake pads.

  2. Disconnect the gauge assembly connector B (22P), and brake fluid level switch 2P connector.
  3. Check for continuity between terminal No. 19 of the gauge assembly connector B (22P) and body ground.
    Fig 1: Checking Continuity Between Terminal No. 19 Gauge Assembly Connector B (22P) And Body Ground
    G04547517Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Is there continuity? 

    YES  - Repair short to ground in the wire between the gauge assembly connector B and the brake fluid level switch.

    NO  - Go to step 4.

  4. Check the brake fluid level switch (see BRAKE FLUID LEVEL SWITCH TEST ).

    Is the switch OK? 

    YES  - Do the troubleshooting for the gauge assembly (see SELF-DIAGNOSTIC FUNCTION ).

    NO  - Replace the brake fluid level switch.