LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2005 >> Element EX, 2.4 YH2, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> DTC Troubleshooting >> DTC P0711: Problem in ATF Temperature Sensor Circuit

DTC P0711: Problem in ATF Temperature Sensor Circuit

NOTE:
  • Record all freeze data and review General Troubleshooting Information (see GENERAL TROUBLESHOOTING INFORMATION ) before you troubleshoot.
  • This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.
  1. Check the ATF temperature with the HDS.

    Does the ATF temperature exceed the ambient-air temperature? 

    1. YES-  Record the ATF temperature. Leave the engine off for more than 30 minutes, and go to step 2.
    2. NO-  Record the ATF temperature. Test the stall speed RPM (see STALL SPEED TEST ) three times. Go to step 2 after stall speed testing.
  2. Check the ATF temperature with the HDS.

    Did the ATF temperature change? 

    1. YES-  Leave the engine off for at least 30 minutes, and go to step 3.
    2. NO-  Replace ATF temperature sensor (see step ATF TEMPERATURE SENSOR TEST/REPLACEMENT ), then go to  5.
  3. Check the ECT SENSOR with the HDS.

    Is the ECT SENSOR equal to the ambient-air temperature? 

    1. YES-  Go to step 4.
    2. NO-  Leave the engine off until ECT sensor equals ambient-air temperature, then go to step 4.
  4. Check the ATF temperature with the HDS.

    Is the ATF temperature almost equal to ECT SENSOR? 

    1. YES-  Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the ATF temperature sensor and PCM.
    2. NO-  Replace ATF temperature sensor (see ATF TEMPERATURE SENSOR TEST/REPLACEMENT ), then go to step 5.
  5. Clear the DTC with the HDS.
  6. Test-drive the vehicle for several minutes in the D position through all four gears.
  7. Monitor the OBD status for P0711 with the DTC Monitor Tool in DTCs/Freeze Data in A/T Mode Menu for a pass/fail.

    Does the result indicate PASSED? 

    1. YES-  Troubleshooting is complete.
    2. NO-  Return to step  1 and recheck.