LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2004 >> Civic HX, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Idle Control System (All Except Hatchback & Hybrid) >> A/C Signal Circuit Troubleshooting

A/C Signal Circuit Troubleshooting

  1. Turn the ignition switch ON (II).
  2. Momentarily connect ECM/PCM connector terminals A24 and E18 with a jumper wire several times.
    Fig 1: Connecting ECM/PCM Connector Terminals A24 & E18 With Jumper Wire
    G01401952Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Is there a clicking noise from the A/C compressor clutch? 

    1. YES  - Go to step 3.
    2. NO  - Go to step  6.
  3. Start the engine.
  4. Turn the blower switch ON.
  5. Turn the A/C switch ON.

    Does the A/C operate? 

    1. YES  - The air conditioning signal is OK.
    2. NO  - Update the ECM/PCM if it does not have the latest software, or substitute a known-good ECM/PCM, then recheck (see ECM/PCM UPDATING, SUBSTITUTION AND REPLACEMENT ). If the symptom/indication goes away with a known-good ECM/PCM, replace the original ECM/PCM.
  6. Momentarily connect under-hood fuse/relay box 14P connector terminal No. 10 to body ground with a jumper wire several times.
    Fig 2: Connecting Under-Hood Fuse/Relay Box 14P Connector Terminal No. 10 To Body Ground With Jumper Wire
    G01401953Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Is there clicking noise from the A/C compressor clutch? 

    1. YES  - Repair open in the wire between the ECM/PCM (E18) and the A/C clutch relay.
    2. NO  - Check the A/C system for other symptoms.