LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2003 >> Element DX, 2.4 YH1, Standard >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating/Air Conditioning >> A/C Compressor Replacement

A/C Compressor Replacement

  1. If the A/C compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off.
  2. Make sure you have the anti-theft code for the radio, then write down the frequencies for the radio's preset buttons.
  3. Disconnect the negative cable from the battery.
  4. Recover the refrigerant with a recovery/recycling/charging station (see REFRIGERANT RECOVERY ).
  5. Remove the radiator reservoir tank.
  6. Remove the power steering pump (see PUMP REPLACEMENT ).
  7. Remove the alternator (see ALTERNATOR REMOVAL AND INSTALLATION ).
  8. Remove the bulkhead cover and bulkhead (see RADIATOR AND FAN REPLACEMENT ).
  9. Remove the A/C compressor clutch connector (A) from the A/C condenser fan shroud (B), then open the wire harness clip. Disconnect the A/C condenser fan connector (D). Remove the upper mounting bolts and the A/C condenser fan shroud. Be careful not to damage the radiator fins when removing the A/C condenser fan shroud.
    Fig 1: Removing A/C Compressor Clutch Connector From A/C Condenser Fan Shroud And Torque Specifications
    G03679659Courtesy of AMERICAN HONDA MOTOR CO., INC.
  10. Disconnect the A/C compressor clutch connector (A), remove the nuts, then disconnect the suction line (B) and the discharge line (C) from the A/C compressor. Plug or cap the lines immediately after disconnecting them to avoid moisture and dust contamination.
    Fig 2: Disconnecting A/C Compressor Clutch Connector And Torque Specifications
    G03679660Courtesy of AMERICAN HONDA MOTOR CO., INC.
  11. Remove the mounting bolts and the A/C compressor. Be careful not to damage the radiator fins when removing the A/C compressor.
    Fig 3: Removing Mounting Bolts And A/C Compressor And Torque Specifications
    G03679661Courtesy of AMERICAN HONDA MOTOR CO., INC.
  12. Install the A/C compressor in the reverse order of removal, and note these items:
    • If you're installing a new A/C compressor, you must calculate the amount of refrigerant oil to be removed from it (see page A/C SERVICE TIPS AND PRECAUTIONS .
    • Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the correct O-rings for HFC-134a (R-134a) to avoid leakage.
    • Use refrigerant oil (DENSO ND-OIL 8) for HFC-134a DENSO piston type A/C compressor only.
    • To avoid contamination, do not return the oil to the container once dispensed, and never mix it with other refrigerant oils.
    • Immediately after using the oil, reinstall the cap on the container, and seal it to avoid moisture absorption.
    • Do not spill the refrigerant oil on the vehicle; it may damage the paint; if the refrigerant oil contacts the paint, wash it off immediately.
    • Be careful not to damage the radiator fins when installing the A/C compressor and the A/C condenser fan shroud.
    • Charge the system (see SYSTEM CHARGING ).
    • Do the ECM/PCM idle learn procedure (see ECM/PCM IDLE LEARN PROCEDURE ).
    • Perform the power window control unit reset procedure (see RESETTING THE POWER WINDOW CONTROL UNIT ).
    • Enter the anti-theft code for the radio, then enter the audio presets.
    • Reset the clock.