LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2001 >> Insight Automatic CVT >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission Servicing >> Adjustments >> Shift Control Cable >> Cr-V (2002)

Cr-V (2002)

  1. Turn ignition off. Remove driver's dashboard lower cover, located below steering column. Remove instrument cluster gauge assembly.
  2. Turn ignition on. Shift gearshift lever to "R" position. Turn ignition off. Slide lock tab on shift cable end holder downward. Using needle nose pliers, grasp shift cable lock in the middle. See Fig 1 . Remove lock from shift cable end and holder. Do not pry on shift cable lock with a screwdriver. Damage may occur to holder. Separate shift cable from shift cable holder.
  3. Rotate socket holder on shift cable 1/4 turn. Tab on socket holder will be in opening of socket holder bracket. Slide holder to remove shift cable from socket holder bracket. See Fig 2 . Do not remove shift cable by twisting shift cable guide and damper.
    Fig 1: Removing Lock From Holder (CR-V - 2002)
    G00072609Courtesy of AMERICAN HONDA MOTOR CO., INC.
    Fig 2: Removing Shift Cable From Bracket (CR-V - 2002)
    G00072610Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Push shift cable down until it stops, then release it. Pull shift cable back one step so that shift cable is in "R" position. Do not hold shift cable guide to adjust shift cable. Turn ignition on and verify that "R" position indicator comes on.
  5. Turn ignition off. Insert a .24" (6.0 mm) pin into positioning holes on gearshift lever bracket base and through positioning hole on gearshift lever. See Fig 3 . Gearshift lever must be in "R" position.
  6. Rotate socket holder on shift cable to face tab on holder opposite of opening in socket holder bracket. Align holder with opening in bracket, then slide holder into bracket. Rotate holder 1/4 turn to secure shift cable. Do not install shift cable by twisting shift cable guide and damper.
  7. Install shift cable end in shift cable end holder. Keep shift cable end and holder free of grease. Install NEW shift cable lock to secure shift cable end and shift cable end holder, then push lock tab up until it stops to lock the joint. See Fig 4 .
  8. Remove .24" (6.0 mm) pin from gearshift lever. Move gearshift lever to each gear position, and verify A/T gear position indicator is in agreement with transmission range sensor. Allow front wheels to rotate. Start engine and check shift lever operation in all gears. Reinstall instrument cluster gauge assembly and lower cover.
    Fig 3: Aligning Positioning Holes (CR-V - 2002)
    G00072614Courtesy of AMERICAN HONDA MOTOR CO., INC.
    Fig 4: Installing Cable Lock (CR-V - 2002)
    G00072615Courtesy of AMERICAN HONDA MOTOR CO., INC.