LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> Insight >> Repair and Diagnosis >> Drivelines & Axles >> Axle Shafts >> Driveline/Axle >> Driveshaft Installation

Driveshaft Installation

  1. Apply 0.3- 1.0 g (0.01 -0.04 oz) of specified grease to the whole splined surface (A) of the driveshaft. After applying grease, remove the grease from the splined grooves at intervals of 2-3 splines and from the set ring groove (B) so that air can bleed from the differential.
    Fig 1: Installing Driveshaft
    G03682234Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Install a new set ring onto the set ring groove of the driveshaft.
  3. Clean the areas where the driveshaft contacts the differential thoroughly with solvent or brake cleaner, and dry with compressed air. Do not wash the rubber parts with solvent. Insert the inboard end (A) of the driveshaft into the differential (B) until the set ring (C) locks in the groove (D).
    Fig 2: Installing New Set Ring Onto Set Ring Groove Of Driveshaft
    G03682235Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Install the inboard boot heat shield (A).
    Fig 3: Installing Inboard Boot Heat Shield And Torque Specifications
    G03682236Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Install the outboard joint (A) into the front hub (B).
    Fig 4: Installing Outboard Joint Into Front Hub
    G03682237Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Install the knuckle (A) onto the lower arm (B). Be careful not to damage the ball joint boot (C). Wipe off the grease before tightening the nut at the ball joint. Torque the castle nut (D) to the lower torque specification, then tighten it only far enough to align the slot with the ball joint pin hole. Do not align the nut by loosening it.
    NOTE: Make sure the ball joint boot is not damaged or cracked.
    Fig 5: Installing Knuckle Onto Lower Arm
    G03682238Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Install the new cotter pin (E) into the ball joint pin hole.
  8. Install the ABS wheel sensor harness clamp (A) and brake hose clamp (B).
    Fig 6: Installing ABS Wheel Sensor Harness Clamp And Brake Hose Clamp With Specified Torques
    G03682239Courtesy of AMERICAN HONDA MOTOR CO., INC.
  9. Connect the front stabilizer link (A) and front stabilizer (B). Hold the stabilizer link ball joint pin (C) with a hex wrench (D), and tighten the new flange nut (E).
    Fig 7: Connecting Front Stabilizer Link And Front Stabilizer With Specified Torques
    G03682240Courtesy of AMERICAN HONDA MOTOR CO., INC.
  10. Install a new spindle nut (A), then tighten the nut. After tightening, use a drift to stake the spindle nut shoulder (B) against the driveshaft.
    Fig 8: Installing A New Spindle Nut And Torque Specifications
    G03682241Courtesy of AMERICAN HONDA MOTOR CO., INC.
  11. Clean the mating surfaces of the brake disc and the front wheel (C), then install the front wheel with the wheel nuts (D). Install the center cap (E).
  12. Turn the front wheel by hand, and make sure there is no interference between the driveshaft and surrounding parts.
  13. Refill the transmission with recommended transmission fluid:
  14. Check the front wheel alignment, and adjust it if necessary (see WHEEL ALIGNMENT ).