LEMON Manuals: Even more car manuals for everyone

Tach Pulse Signal

WARNING: This page is about a different variant/trim than selected.
  1. Timing control and triggering of fuel injectors are based upon input signals from TDC/CRANK/CYL sensors. These sensors are simple Permanent Magnet (PM) generator pick-up coils.
  2. Using a DVOM on low voltage scale (preferably with a bar-graph function), check for a pulsed low-voltage signal at proper Engine Control Module (ECM) harness terminals with engine cranking. Refer to the WIRING HARNESS & SENSOR RESISTANCE TEST  . Also, See Fig 1 . If a pulsed signal is present, fault does not exist. If pulsed signal is not present, check sensor and wiring integrity.
    Fig 1: Identifying ECM Wire Harness Connector Terminals
    G92E26660Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. To test sensor and wiring integrity, turn ignition off. Disconnect connectors from ECM. Lightly probe appropriate ECM harness terminals to check for proper winding resistance of each sensor. See WIRING HARNESS & SENSOR RESISTANCE TEST  . If resistance is within specification, go to step 5). If resistance is not within specification, go to next step.
  4. Check resistance of TDC/CRANK/CYL sensor directly at sensor connector. See TDC/CRANK/CYL SENSOR RESISTANCE TEST  . If sensor resistance is within specification, repair open, short or corrosion in wire harness between sensor(s) and ECM. If resistance is not within specification, replace sensor.
  5. Check continuity to ground at each ECM sensor terminal. If continuity is not present, replace distributor housing. If continuity is present, go to next step.
  6. Disconnect sensor(s) and recheck for continuity to ground at ECM harness sensor terminals. If continuity no longer exists, go to next step. If continuity to ground is still present, repair short to ground in ECM harness between ECM and sensor(s).
  7. Check continuity to ground on each sensor connector terminal. See TDC/CRANK/CYL SENSOR RESISTANCE TEST  . Continuity should not exist. If continuity to ground exists, replace sensor.
    WIRING HARNESS & SENSOR RESISTANCE TEST

    Application Terminals Ohms
    CRANK B8 & B16 1800-2500
    CYL B6 & B14 1500-3000
    TDC B7 & B15 1500-3000
    TDC/CRANK/CYL SENSOR RESISTANCE TEST (1)

    Application Terminals Wire Color
    CRANK Sensor Wire
    1 Of 2 1 Blue
    2 Of 2 2 White
    CYL Sensor Wire
    Term. No. 3 B6 Yellow
    Term. No. 4 B14 Black
    TDC Sensor Wire
    Term. No. 1 B7 Green
    Term. No. 2 B15 Red
    (1) CRANK sensor is located behind crankshaft pulley and CYL/TDC sensor is located behind front camshaft pulley.