LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 1990 >> Prelude Si, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Testing >> Set/Resume Switch Testing

Set/Resume Switch Testing

  1. Remove dashboard lower trim panel. Disconnect steering column 14-pin connector. With SET switch on, continuity should exist between terminals "A" and "B". See Fig 1 . With RESUME switch on, continuity should exist between terminals "A" and "C". If continuity is okay, switch is functioning properly. No further testing is required.
    Fig 1: Testing Set/Resume Switch (Prelude)
    G91A02787Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. If continuity is incorrect, remove steering wheel. Disconnect 3-pin connector. With SET switch on, continuity should exist between terminals "A" and "B". See Figure . With RESUME switch on, continuity should exist between terminals "A" and "C". If continuity is incorrect in one or all switch positions, replace switch. If continuity is okay in all switch positions, check slip ring.