LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 1988 >> Civic Base, 2D Hatchback >> Repair and Diagnosis >> Engine Performance >> System >> Electronic Control System >> Testing >> CODE 9: TDC/CRANK/CYL SENSOR (CIVIC HF & Si)

CODE 9: TDC/CRANK/CYL SENSOR (CIVIC HF & Si)

  1. Turn off ignition. Remove hazard fuse in main fuse box for 10 seconds to reset ECU. Start engine and observe Check Engine light. If light is off, problem is intermittent. Test drive and check again.
  2. If light is on, turn ignition off. Disconnect 8-wire sensor connector nearest the sensor. Measure resistance between Blue/Green and Blue/Yellow wire of sensor. If reading is not 350-550 ohms, replace distributor assembly. If reading is within specification, proceed to next step.
  3. Check continuity between ground and Blue/Green and Blue/Yellow wire sensor terminals. If continuity exists, replace distributor assembly. If no continuity exists, proceed to next step.
  4. Reconnect sensor connector. Attach system checker harness to main wire harness only, not to ECU. Check resistance between connector terminals C1 and C2. Resistance should be 350-550 ohms.
  5. If resistance is not within specification, repair open in Blue/Green and/or Blue/Yellow wires. If resistance is within specification, substitute a known good ECU. If condition is rectified, replace original ECU.