LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 1988 >> Civic Base, 2D Hatchback >> Repair and Diagnosis >> Engine Performance >> System >> Electronic Control System >> Testing >> CODE 4: TDC/CRANK/CYL SENSOR (CIVIC HF & Si)

CODE 4: TDC/CRANK/CYL SENSOR (CIVIC HF & Si)

  1. Turn off ignition. Remove hazard fuse in main fuse box for 10 seconds to reset ECU. Start engine and observe Check Engine light. If light is off, problem is intermittent. Test drive and check again.
  2. If light is on, turn ignition off. Unplug 8-wire TDC/CRANK/CYL sensor connector at distributor. Measure resistance between terminals "C" and "D". If continuity exists, sensor is shorted to ground. Replace distributor assembly.
  3. If continuity to ground did not exist in step 2), reconnect 8-wire connector. Connect system checker harness to main harness only, not to ECU. Measure resistance between terminals B10 and B12. If resistance is not 350-550 ohms, repair Orange and/or White wires.
  4. If resistance is within specification, substitute a known good ECU. If condition is rectified, replace original ECU.
Fig 1: Civic HF & Si TDC/CRANK/CYL Sensor Connector
G94645