LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 1988 >> Civic Base, 2D Hatchback >> Repair and Diagnosis >> Engine Performance >> Ignition System - TOYO DENSO Electronic >> Overhaul >> Civic >> Reassembly

Ignition System - TOYO DENSO Electronic: Overhaul: Civic: Reassembly

  1. Install new crank/cylinder sensor in the distributor housing with 2 new 4x9mm Phillips screws. Do not tighten screws.
  2. Screw gauge shaft into base of Distributor Sensor Adjustment Tool (T/N 07LAG-0010000A ), then secure base in a vise. Install rubber cap on end of gauge shaft, then slide distributor housing over shaft. DO NOT damage distributor shaft seal. Remove rubber cap, then slide air gap setting gauge (PM5) over gauge shaft. Hold crank/cylinder sensor pick-up against gauge, then tighten sensor mounting screws. Remove distributor from tool.
  3. Install rubber cap on end of distributor shaft. slide baseplate/distributor shaft assembly into distributor housing. Install 3 new baseplate TORX screws finger-tight. Rotate baseplate to align scribe marks made during DISASSEMBLY, then tighten TORX screws.
  4. Install 6-pin connector on bracket and secure harness with 2 clamps. Install condenser mounting screw. Install new TDC sensor with new TORX screws. DO NOT tighten screws. Using a feeler gauge, set air gap between TDC sensor pick-up and reluctor to 0.3mm. Tighten sensor mounting screws.
  5. Install ignition coil and reconnect wires. Install rotor with new rotor screw. Turn rotor so that it faces No. 1 cylinder. See Fig 3. Install thrust washers and coupling on shaft. With rotor pointing at No. 1 cylinder, align index mark on housing with index mark on coupling. See Fig 3. Drive in pin and secure with pin retainer. Install leak cover, cap seal and distributor cap.
  6. Reset PGM-FI ECU. Install distributor in cylinder head. Warm engine to operating temperature and check timing.
NOTE: If CODE 4 or 8 appears on PGM-FI ECU, recheck alignment of baseplate screws to scribe marks, and TDC sensor air gap.
Fig 1: Distributor Removal & Installation (Civic)
G121843Courtesy of AMERICAN HONDA MOTOR CO., INC.
Fig 2: Exploded View of Distributor (Civic)
G94164Courtesy of AMERICAN HONDA MOTOR CO., INC.
Fig 3: Distributor Coupling Installation (Civic)
G94165Courtesy of AMERICAN HONDA MOTOR CO., INC.