LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 1988 >> Civic Base, 2D Hatchback >> Repair and Diagnosis >> Engine Performance >> Ignition System - TOYO DENSO Electronic >> Overhaul >> Civic >> Disassembly

Ignition System - TOYO DENSO Electronic: Overhaul: Civic: Disassembly

  1. Disconnect 2-pin and 6-pin connectors from distributor. Label, then disconnect spark plug wires from distributor cap. Remove distributor hold down bolts and remove distributor from cylinder head. See Figure.
  2. Remove pin retainer, pin, coupling and thrust washers from distributor shaft. Remove distributor cap, cap seal, leak cover and rotor. Remove the 6-pin connector from 2 clamps, then remove 6-pin connector from its mounting bracket.
  3. Remove the screw that mounts the condenser to the distributor housing. Using a small flat tip screwdriver, disconnect 4 wires from ignitor, then remove ignitor.
  4. Remove 2 screws to disconnect Black/Yellow and White/Blue wires from ignition coil, then remove 4 screws and slide ignition coil out of distributor housing.
  5. Remove 2 tamper resistant screws that secure TDC sensor.
    NOTE: Two types of tamper resistant screws are used, TORX screws and shear screws. TORX screws can be removed with a T15R TORX driver for tamper resistant screws. To remove the shear screws, slot the heads of the screws with a hacksaw and remove them with a flat tip screwdriver.
    NOTE: If tamper resistant screws do not loosen easily, carefully heat around the screw holes with a small torch to loosen the thread lock.
    CAUTION: DO NOT allow torch flame to burn any wires or distributor shaft seal.
  6. Scribe around the 3 baseplate screws to mark position of baseplate.
    NOTE: With scribed reference marks, distributor can not be assembled properly.
  7. Remove the baseplate/distributor shaft assembly from the distributor housing by maneuvering the TDC sensor through the baseplate opening.
  8. Remove the 2 crank/cylinder sensor screws. Remove sensor from distributor housing.