LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1996 >> Metro Base, 2D Hatchback, 1.0 6 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests 1.0 & 1.3L >> Engine Sensors & Switches >> Manifold Absolute Pressure (Map) Sensor

Manifold Absolute Pressure (Map) Sensor

A malfunction in MAP sensor circuit can set DTCs P0106, P0107 and P0108. For testing procedures, see appropriate TESTS W/CODES article. Use the following procedure to diagnose MAP sensor. If driveability problems exist, MAP sensor failure is suspected and no DTCs are set, disconnect MAP sensor connector. If driveability improves, replace MAP sensor.

  1. MAP sensor is located on firewall. With ignition on, check supply voltage from PCM to MAP sensor on designated wire terminal. See WIRING DIAGRAMS  section. Reading should be approximately 5 volts.
  2. Disconnect vacuum hose at MAP sensor. Install hand-held vacuum pump. Turn ignition on. Check signal voltage at designated wire terminal of MAP sensor. See WIRING DIAGRAMS  section.
  3. Apply vacuum and note change in signal voltage. As vacuum reading changes, signal voltage should change. Reading should be about 1-1.5 volts at high vacuum (idle position), or 4-4.5 volts at low vacuum (full throttle position).