LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1993 >> Prizm Base, Standard >> Repair and Diagnosis >> Transmission >> Clutches >> Removal & Installation >> Clutch Assembly >> Inspection

Clutch Assembly: Inspection

  1. Check wear on disc's facing by measuring depth of each rivet head. Minimum depth at any rivet is .012" (.30 mm). Maximum runout of clutch disc facing is .031" (0.8 mm). Replace clutch disc if runout is not within specification.
  2. Check pressure plate for warpage, heat marks (blue coloration) and cracks. Check diaphragm spring fingers for uneven height and wear at throw out bearing contact area. See Fig 1 . Replace pressure plate if worn. Check pilot bearing rotation. If roughness is felt, replace bearing.
    Fig 1: Measuring Diaphragm Spring Wear
    G93E00202Courtesy of GENERAL MOTORS CORP.
  3. Inspect flywheel runout. Maximum flywheel runout is .004" (.10 mm). If runout is excessive, replace flywheel. Clean oil, grease and metal deposits from flywheel and pressure plate. Inspect for damage, cracks or warpage. Slight surface scoring can be removed with sandpaper. Replace or repair as necessary.