LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2025 >> GV70 3.5T Sport Advanced >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Control System - 2.5L) >> Rail Pressure Sensor (RPS) >> Removal And Installation

Removal And Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Install the component to the specified torques.
  • Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
  1. Release the Residual Pressure in Fuel Line.

    (Refer to Fuel Delivery System - "RELEASE RESIDUAL PRESSURE IN FUEL LINE ")

  2. Switch "OFF" the ignition and disconnect the battery negative (-) terminal.
  3. Remove the Intake Manifold.

    (Refer to Engine Mechanical System - "INTAKE MANIFOLD ")

  4. Remove the delivery pipe foam (A).
    G16846966Courtesy of HYUNDAI MOTOR AMERICA
  5. Disconnect the rail pressure sensor connector (A)
    G16846967Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the rail pressure sensor (A) from the delivery pipe.

    Tightening torque: 

    30.4 - 35.3 N.m (3.1 - 3.6 kgf.m, 22.4 - 26.0 lb-ft)

    G16846968Courtesy of HYUNDAI MOTOR AMERICA
  7. Install in the reverse order of removal.