LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2022 >> GV70 2.5T Select >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Front Seat Belt >> Front Seat Belt Pretensioner >> Replacement

Front Seat Belt Pretensioner: Replacement

CAUTION:
  • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
  • Put on gloves to prevent hand injuries.
  1. Remove the center pillar upper trim.

    (Refer to Interior Trim - "CENTER PILLAR TRIM ")

  2. Remove the front anchor seat belt (A).
    G14754567Courtesy of HYUNDAI MOTOR AMERICA

    Information 

    • Removal method for anchor seat belt.
    • Push the front anchor seat belt (A) in the direction of.
    • Insert the screwdriver in the direction of.
    • Remove the front anchor seat belt (A) by pulling it in the direction of.
      CAUTION:
      • Make sure not to scratch the anchor cover by the tool when pushing the slot hole.
  3. Loosen the mounting bolt and remove the front seat belt upper anchor (A).

    Tightening torque: 

    39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb-ft)

    G14754568Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the front seat belt pretensioner connector (A).
    G14754569Courtesy of HYUNDAI MOTOR AMERICA
  5. Loosen the mounting bolt and remove the front seat belt pretensioner (A).

    Tightening torque: 

    Bolt B: 7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)

    Bolt C: 39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb-ft)

    G14754570Courtesy of HYUNDAI MOTOR AMERICA
  6. To install, reverse removal procedure.

    Information 

    • When installing the connector, be sure to insert it to the anchor pretensioner until "click" sound is heard and then check it for secure installation by pulling it.
    • After installing the front seat belt retractor, check that the air bag warning indicator illuminates for about 6 seconds when the ignition is ON and then goes out.
    • Make sure the connector is plugged in properly.
    • Replace any damaged clips (or pin-type retainers).