LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2021 >> GV80 3.5T Advanced+ >> Repair and Diagnosis >> Steering >> Steering Column >> Motor Driven Power Steering System >> Steering Column & Shaft >> Repair Procedures >> Removal

Repair Procedures: Removal

  1. Turn the steering wheel so that the front wheels are placed in the straight ahead position.
    CAUTION:
    • If the steering wheel and the front tires are not set straight ahead together, it may affect the number of circulation of steering wheel and damage the cable inside the clock spring.
  2. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
    WARNING:
    • Disconnect the battery negative cable from the battery and then wait for at least 30 seconds.
  3. Remove the driver airbag module (DAB).

    (Refer to Restraint - "DRIVER AIRBAG (DAB) MODULE & CLOCK SPRING ")

  4. Remove the steering wheel.

    (Refer to Steering System - "STEERING WHEEL ")

  5. Remove the clock spring.

    (Refer to Restraint - "DRIVER AIRBAG (DAB) MODULE & CLOCK SPRING ")

  6. Remove the steering column shroud upper panel.

    (Refer to Body - "STEERING COLUMN SHROUD PANEL ")

  7. Remove the crash pad lower panel.

    (Refer to Body - "CRASH PAD LOWER PANEL ")

  8. Remove the knee airbag.

    (Refer to Restraint - "KNEE AIRBAG (KAB) ")

  9. Disconnect the electric steering column lock switch connector (A).
    G14722716Courtesy of HYUNDAI MOTOR AMERICA
  10. Remove the wiring clip (A).
    G14722717Courtesy of HYUNDAI MOTOR AMERICA
  11. Disconnect the tilt & telescopic connector (A).
    G14722718Courtesy of HYUNDAI MOTOR AMERICA
    G14722719Courtesy of HYUNDAI MOTOR AMERICA
  12. Remove the wiring clip (A).
    G14722720Courtesy of HYUNDAI MOTOR AMERICA
  13. Loosen the bolt (A) and then separate the universal joint from the steering column and shaft.

    Tightening torque 

    32.4 - 37.3 N.m (3.3 - 3.8 kgf.m, 23.9 - 27.5 lb-ft)

    G14722721Courtesy of HYUNDAI MOTOR AMERICA
    NOTE:
    • Keep the steering wheel in a neutral position. Moving the steering wheel may damage the cable inside the clock spring.
    • Tighten the steering column bolts in the same direction as they were removed.
    • Do not reuse the universal joint bolt when installing.
  14. Loosen the steering column dust cover nut (A).

    Tightening torque: 

    12.7 - 17.7 N.m (1.3 - 1.8 kgf.m, 9.4 - 13.0 lb-ft)

    G14722722Courtesy of HYUNDAI MOTOR AMERICA
  15. Remove the steering column and shaft by loosening the mounting nuts (A) and bolt (B).

    Tightening torque 

    1. 25.0 - 29.4 N.m (2.5 - 3.0 kgf.m, 14.5 - 21.7 lb-ft)
    2. 53.9 - 58.8 N.m (5.5 - 6.0 kgf.m, 39.8 - 43.4 lb-ft)
      G14722723Courtesy of HYUNDAI MOTOR AMERICA
      G14722724Courtesy of HYUNDAI MOTOR AMERICA