LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2018 >> G90 3.3T Premium, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Cooling System - 5.0L) >> Water Temperature Control Assembly >> Repair Procedures >> Removal And Installation >> Water Temperature Control Assembly

Water Temperature Control Assembly

WARNING: This page is about a different variant/trim than selected.
  1. Remove the air cleaner assembly.

    (Refer to Intake and Exhaust System - "AIR CLEANER ")

  2. Remove the air duct and air intake hose.

    (Refer to intake and exhaust system - "AIR CLEANER ")

  3. Drain the coolant.

    (Refer to Cooling System - "COOLANT ")

  4. Disconnect the radiator lower hose (A).
    G12720063
  5. Remove the knock sensor wiring bracket bolt (A).
    G12720064
  6. Remove the ETC (Electronic Throttle Control) module.

    (Refer to Engine Control/Fuel System - "ETC (ELECTRONIC THROTTLE CONTROL) SYSTEM ")

  7. Remove the engine temperature control assy connector (A).
  8. Disconnect the ventilation hose (B).
  9. Remove the engine coolant temperature control assembly (C).

    Tightening torque: 

    16.7 - 19.6 N.m (1.7 - 2.0 kgf.m, 12.3 - 14.5 lb-ft)

    G12720065
    NOTE:
    • Always use a new gasket.
  10. Install in the reverse order of removal.