LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2018 >> G90 3.3T Premium, RWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Electronic Stability Control Diagnosis >> DTC C1702-04: ABS ESP ESC Control Module Variant Coding >> DTC Inspection >> GDS Data Analysis >> Variant Coding (In Case That The GDS Isn't Connected To The Internet)

Variant Coding (In Case That The GDS Isn't Connected To The Internet)

  1. Connect GDS to Data Link Connector (DLC).
  2. Ignition switch 'ON'.
  3. Perform variant coding in Vehicle S/W Management menu of the GDS. (figure 4).
  4. Log in GSW website (http://ccc.hyundai-motor.com/) and then click "VIN Search" at the top center side of the screen.
  5. Select ESP (ESC) and fill in VIN number (or body number) correctly, and check ESP (ESC) code. (Fig. 5)
  6. Fill in the blank with ESP (ESC) code checked in GSW web site. (Fig.6)
  7. Check whether current variant code corresponds to the options which are applied to the vehicle.
  8. Ignition switch 'OFF' and wait for about 10 seconds, and then ignition switch 'ON'. Go to "Variant Code Reset" procedure.
    NOTE: In case that the state of HAC is enabled, operate "Longitudinal G Sensor Calibration" by GDS.