Installation Procedure
Windshield (1) - Install - Adhesive Installation of Windshields
Clean the windshield surface and sensor bracket with an Isopropanol Alcohol, wipe until the surfaces are thoroughly clean.
- Inside Air Moisture and Windshield Temperature Sensor (1) - Install NEW
If equipped, install the front view driver information camera bracket (1) to the windshield and slide downward to engage the pins.
Connect the electrical connector.
- {If equipped} Front View Camera - Install
Inside Rearview Mirror (2) - Install
- Slide the mirror onto the rearview mirror button.
- Connect the electrical connector.
- Inside Rearview Mirror Bolt (1) - Install and tighten - Fastener Specifications
Connect the electrical connector.
- Windshield Multifunction Sensor Mount Bracket Cover (1) - Install
Windshield Multifunction Sensor Mount Bracket Cover Insert (1) - Install
Windshield Wiper System Module Shield (1) - Install
- NOTE:
Quantity of retainers may vary based on option content.
Air Inlet Grille Panel (2) - Install
- Connect the windshield washer nozzle hose to the windshield washer pump hose.
- Air Inlet Grille Panel Retainer (1) - Install [8x]
Hood Rear Outer Air Inlet Seal (2) - Install [2x]
- Hood Rear Outer Air Inlet Seal Retainer (1) - Install [2x]
- NOTE:
Quantity of retainers may vary based on option content.
Air Inlet Grille Panel Extension - Left Side (1) - Install
- Remove the double layer of masking tape around the perimeter of the painted surfaces.
- Using a 50/50 mixture of isopropyl alcohol and clean drinkable water with a clean towel, remove any left over adhesive residue from the masking tape.
- NOTE:
Quantity of retainers may vary based on option content.
Air Inlet Grille Panel Extension - Right Side (1) - Install
- Remove the double layer of masking tape around the perimeter of the painted surfaces.
- Using a 50/50 mixture of isopropyl alcohol and clean drinkable water with a clean towel, remove any left over adhesive residue from the masking tape.
Radio Antenna (1) - Install
- Rotate the antenna clockwise to secure the radio antenna (1) to the antenna base.
Clean the left and right side windshield wiper transmission pivot shaft splines with a soft wire brush before installing the windshield wiper arm (3).
- Position the windshield wiper arms (3) on the windshield wiper transmission pivot shafts.
- Windshield Wiper Arm Nut (2) - Install and tighten - Fastener Specifications
- Windshield Wiper Arm Finish Cap (1) - Install [2x]
If required, realign the windshield wipers to their respective alignment circles (1) on the windshield.
- Lubricate the windshield with clean washer fluid.
- Run the windshield wipers for two complete cycles then turn off the windshield wipers.
- Ensure the windshield wipers are in the full park position.
- Enable the SIR System. SIR Disabling and Enabling
Refer to Fastener Caution .