Circuit/System Testing
- Ignition ON, engine running.
- Verify that no other DTCs are set.
- If any other DTCs are set
- Go to next step: If no other DTCs are set
- Verify that DTC C158C is set.
- If DTC C158C is set
- Replace the Steering Gear Pressure Sensor
- Ignition ON, engine running.
- Verify DTC C158C does not set while operating the vehicle within the Conditions for Running the DTC.
- If the DTC is set
- Replace the K43 Power Steering Control Module.
- Go to next step: If DTC C158C is not set
- All OK.