LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2024 >> Sierra 2500 HD Denali Ultimate >> Repair and Diagnosis >> Electrical >> Body Electrical >> Power Outlets >> Repair Instructions >> Accessory AC and DC Power Control Module Replacement (Regular Cab) >> Removal Procedure

Removal Procedure

  1. Disable the SIR system. SIR Disabling and Enabling
  2. Fold the center seat armrest to the down position.
  3. Recline both front seat backs forward and slide both seats forward.
  4. GM5158756Courtesy of GENERAL MOTORS COMPANY

    Carefully pull the rear window lower garnish molding (1) forward around all edges then the middle of the part to disengage the clips from the sheet metal.

  5. After all integral clips are disengaged, lift up and forward to clear the 2 rear end panel brackets that the rear window lower garnish molding (1) sits over.
  6. GM5163264Courtesy of GENERAL MOTORS COMPANY

    Use a small flat bladed tool to open the trim panel bolt cap (1) on both sides of the vehicle.

  7. Body Lock Pillar Garnish Molding Bolt (2) - Remove [2x]
  8. Starting at the top and working down with a trim tool, grasp the body lock pillar garnish molding (3) and gently pull the panel away from the body to release the retainers on both sides of the vehicle.
  9. NOTE:

    The body lock pillar garnish molding does not need to be fully removed from the vehicle.

  10. Body Lock Pillar Garnish Molding (3) - Reposition [2x]
  11. GM5160364Courtesy of GENERAL MOTORS COMPANY

    Body Rear Panel Insulator Retainer (1) - Remove [6x]

  12. Carefully pull the body rear panel insulator (2) forward around all edges then the middle of the part to disengage the clips from the sheet metal.
  13. Body Rear Panel Insulator (2) - Remove
  14. GM5161791Courtesy of GENERAL MOTORS COMPANY

    Disconnect the electrical connectors.

  15. Accessory AC and DC Power Control Module Nut (1) - Remove [3x]
  16. Accessory AC and DC Power Control Module (2) - Remove