LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2021 >> Yukon AT4 >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Wheel And Column >> Repair Instructions >> Intermediate Steering Shaft Replacement >> Removal Procedure

Removal Procedure

    CAUTION:

    With wheels of the vehicle facing straight ahead, secure the steering wheel utilizing steering column anti-rotation pin, steering column lock, or a strap to prevent rotation. Locking of the steering column will prevent damage and a possible malfunction of the SIR system. The steering wheel must be secured in position before disconnecting the following components:

    • The steering column
    • The intermediate shaft(s)
    • The steering gear

    After disconnecting these components, do not rotate the steering wheel or move the front tires and wheels. Failure to follow this procedure may cause the SIR coil assembly to become un-centered and cause possible damage to the SIR coil. If you think the SIR coil has became un-centered, refer to your specific SIR coil's centering procedure to re-center SIR Coil.

  1. Secure the steering wheel so it will not turn when the intermediate steering shaft is disconnected.
  2. Remove the left front tire and wheel assembly. Tire and Wheel Removal and Installation (Aluminum Wheel)
  3. Front Wheelhouse Liner- Left Side - Remove - Front Wheelhouse Liner Replacement
  4. GM5002170Courtesy of GENERAL MOTORS COMPANY

    Mid Intermediate Steering Shaft Bolt (1) - Remove

  5. GM5002171Courtesy of GENERAL MOTORS COMPANY

    Upper Intermediate Steering Shaft (1) @ Intermediate Steering Shaft - Separate

  6. Raise and support the vehicle. Lifting and Jacking the Vehicle
  7. GM5512332Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    The proper position of the underbody skid shield is between the underbody splash shield and the front frame.

    {with RC1} Remove the underbody skid shield.

    1. Underbody Skid Shield Bolt (1) - Remove [ 2x ]
    2. Underbody Splash Shield Bolt (2) - Remove [ 2x ]
    3. Underbody Skid Shield (3) - Remove
  8. GM5513633Courtesy of GENERAL MOTORS COMPANY

    {without RC1} Remove the underbody skid shield.

    1. Underbody Skid Shield Bolt (1) - Remove [ 4x ]
    2. Underbody Skid Shield (2) - Remove
  9. GM5540945Courtesy of GENERAL MOTORS COMPANY

    Front Bumper Fascia Air Deflector Bolt (1) - Remove [ 10x ]

  10. Front Bumper Fascia Extension Bolt (2) - Remove [ 8x ]
  11. GM5540946Courtesy of GENERAL MOTORS COMPANY

    Pull the front bumper fascia extension (1) rearward and down from the front bumper fascia.

  12. GM5591893Courtesy of GENERAL MOTORS COMPANY

    Front Bumper Fascia Extension Bolt (2) - Remove [ 4x ]

  13. Pull the front bumper fascia extension rear (4) rearward and down.
  14. GM5002174Courtesy of GENERAL MOTORS COMPANY

    Intermediate Steering Shaft Lower Bolt (1) - Remove

  15. GM5002175Courtesy of GENERAL MOTORS COMPANY

    Intermediate Steering Shaft (1) - Remove