LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2021 >> Yukon AT4 >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Wheel And Column >> Repair Instructions >> Intermediate Steering Shaft Boot Replacement (LM2) >> Removal Procedure

Removal Procedure

  1. Remove the left front tire and wheel assembly. Tire and Wheel Removal and Installation (Aluminum Wheel)
  2. GM5522093Courtesy of GENERAL MOTORS COMPANY

    {If equipped} Front Tire Front Air Deflector Bolt (1) - Remove

  3. GM5513747Courtesy of GENERAL MOTORS COMPANY

    Front Wheelhouse Liner Bolt (1) - Remove [ 3x ]

  4. GM5513749Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Quantity of fasteners may vary based on option content.

    Front Wheelhouse Liner Bolt (1) - Remove [ 3x ]

  5. Front Wheelhouse Liner Retainer (2) - Remove
  6. GM5513751Courtesy of GENERAL MOTORS COMPANY

    Front Wheelhouse Liner Bolt (1) - Remove [ 3x ]

  7. GM5513753Courtesy of GENERAL MOTORS COMPANY

    Front Wheelhouse Liner Bolt (1) - Remove [ 3x ]

  8. GM5513756Courtesy of GENERAL MOTORS COMPANY

    Front Wheelhouse Liner (1) - Remove

  9. CAUTION:

    With wheels of the vehicle facing straight ahead, secure the steering wheel utilizing steering column anti-rotation pin, steering column lock, or a strap to prevent rotation. Locking of the steering column will prevent damage and a possible malfunction of the SIR system. The steering wheel must be secured in position before disconnecting the following components:

    • The steering column
    • The intermediate shaft(s)
    • The steering gear

    After disconnecting these components, do not rotate the steering wheel or move the front tires and wheels. Failure to follow this procedure may cause the SIR coil assembly to become un-centered and cause possible damage to the SIR coil. If you think the SIR coil has became un-centered, refer to your specific SIR coil's centering procedure to re-center SIR Coil.

  10. Secure the steering wheel so it will not turn when the upper intermediate steering shaft and intermediate steering shaft are disconnected.
  11. GM5002170Courtesy of GENERAL MOTORS COMPANY

    Mid Intermediate Steering Shaft Bolt (1) - Remove

  12. GM5002171Courtesy of GENERAL MOTORS COMPANY

    Upper Intermediate Steering Shaft (1) @ Intermediate Steering Shaft - Separate

  13. GM5002244Courtesy of GENERAL MOTORS COMPANY

    Steering Column Seal Nut (1) - Remove [ 3x ]

  14. GM5002246Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    A portion of the main engine harness is not shown for visual clarity.

    Intermediate Steering Shaft Boot (1) - Remove