LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2011 >> Sierra 1500, 4D Pickup Extra Cab, 4.3 X >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 4.3L - Repair Instructions >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Engine Wiring Harness Electrical Connector
    GM1876318Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the engine wiring harness electrical connector (1) from the manifold absolute pressure (MAP) sensor.
  2. Fig 2: View Of MAP Sensor & Bolt
    GM1876319Courtesy of GENERAL MOTORS CORP.
    CAUTION: Do not rotate or pry on the MAP sensor when removing. Damage to the MAP sensor or the intake manifold may result.
  3. Remove the MAP sensor bolt (1).
  4. Using a slight rocking motion while pulling straight up, remove the MAP sensor (2) from the upper intake manifold.
  5. Inspect the MAP sensor seal for damage, replace the seal if necessary.