Removal Procedure
Courtesy of GENERAL MOTORS CORP.
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle
.
- If equipped, remove the oil pan skid plate and bolts.
Courtesy of GENERAL MOTORS CORP.
- Remove the knock sensor heat shield bolt and shield.
Courtesy of GENERAL MOTORS CORP.
- Reposition the knock sensor sleeve (2) down, away from the knock sensor.
- Disconnect the engine wiring harness electrical connector (1) from the knock sensor.
Courtesy of GENERAL MOTORS CORP.
- Remove the knock sensor bolt and sensor.