Draining & Refilling: Draining
- Raise and support vehicle.
- Place a drain pan under the transmission oil pan.
- Remove the oil pan drain plug, if equipped.
- If necessary, remove the bolts and position aside the range selector cable bracket for clearance while lowering the pan. It is not necessary to remove the cable from the lever or bracket.
- Remove the oil pan bolts from the front and sides of the pan only.
- Loosen the rear oil pan bolts approximately 4 turns.
- Lightly tap the oil pan with a rubber mallet in order to loosen the pan to allow the fluid to drain.
- Remove the remaining oil pan bolts.
- Remove the oil pan and the gasket.
- Grasp firmly while pulling down with a twisting motion in order to remove the filter. See Fig 1.
- Remove the filter seal. The filter seal may be stuck in the pump; if necessary, carefully use pliers or another suitable tool to remove the seal.
- Discard the seal.
- Inspect the fluid color.
- Inspect the filter. Pry the metal crimping away from the top of the filter and pull apart. The filter may contain the following evidence for root cause diagnosis:
- Clutch material.
- Bronze slivers indicating bushing wear.
- Steel particles.
- Clean the transmission case and the oil pan gasket surfaces with solvent, and air dry. You must remove all traces of the old gasket material.
Courtesy of GENERAL MOTORS CORP.