LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2001 >> Yukon Base, 5.3 T, 4WD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 4.8L, 5.3L, And 6.0L - Repair Instructions >> Repair Instructions >> Fuel Injection Fuel Rail Assembly Replacement >> Removal Procedure

Removal Procedure

    IMPORTANT:

    An eight-digit identification number (1) is located on the fuel rail assembly. Refer to this model identification number if servicing or part replacement is required.

    Fig 1: Fuel Rail Identification Number Location
    GM380659Courtesy of GENERAL MOTORS COMPANY
  1. Remove the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement (6.0 L w/RPOs Y91 and Z88) , Upper Intake Manifold Sight Shield Replacement (4.8 L, 5.3 L, and 6.0 L) in Engine Mechanical.
  2. Before removal, clean the fuel rail assembly with a spray type engine cleaner, GM X-30A or equivalent, if necessary. Follow the package instructions. Do not soak fuel rails in liquid cleaning solvent.
  3. Fig 2: Locating Accelerator Control Cable and Cruise Control Cable
    GM389853Courtesy of GENERAL MOTORS COMPANY
  4. Disconnect the accelerator control cable and the cruise control cable from the cable bracket.
  5. Fig 3: View Of Accelerator/Throttle Cable
    GM389031Courtesy of GENERAL MOTORS COMPANY
  6. Disconnect the accelerator control cable and the cruise control cable from the throttle body.
  7. Fig 4: Identifying Upper Engine Wire Harness Retainer
    GM310125Courtesy of GENERAL MOTORS COMPANY
  8. Remove the upper engine wire harness retainer nut.
  9. Disconnect the evaporative emission (EVAP) purge valve harness connector.
  10. Reposition the upper engine wire harness aside.
  11. Relieve the fuel system pressure. Refer to Fuel Pressure Relief .
  12. Fig 5: Identifying Lock Release
    GM372749Courtesy of GENERAL MOTORS COMPANY
  13. Identify the connectors to their corresponding injectors to ensure correct sequential injector firing order after reassembly.
  14. Pull the top portion (2) of the injector connector up. Do not pull the top portion of the connector past the top of the white portion (1).
  15. Fig 6: Disconnecting Fuel Injector Electrical Connectors
    GM372753Courtesy of GENERAL MOTORS COMPANY
  16. Push the tab (1) on the lower side of the injector connector in order to release the connector from the injector.
  17. Repeat Step 12 and Step 13 for each injector connector.
  18. Fig 7: View Of Rear Of Engine Fuel Pipe Connections
    GM300360Courtesy of GENERAL MOTORS COMPANY
  19. Disconnect the fuel feed and return pipes (1, 2) from the fuel rail.
  20. Disconnect the fuel pressure regulator vacuum line.
  21. Fig 8: Exploded View Of Fuel Rails & Injector Components
    GM350543Courtesy of GENERAL MOTORS COMPANY
  22. Loosen the crossover tube to right fuel rail retainer screw (22).
  23. Fig 9: View Of Fuel Rail
    GM376389Courtesy of GENERAL MOTORS COMPANY
  24. Remove the fuel rail attaching bolts.
  25. Remove the fuel rail assembly.
  26. Fig 10: View Of Fuel Injector, Clip & O-Rings
    GM351185Courtesy of GENERAL MOTORS COMPANY
  27. Remove the injector lower O-ring seal (4) from the spray tip end of each injector (3).
  28. Discard the O-ring seals.