LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1998 >> Jimmy 4D Utility, RWD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC System - Automatic >> Testing >> Code B0186: Solar Load Sensor Circuit High

Code B0186: Solar Load Sensor Circuit High

  1. Turn ignition switch to OFF position. Disconnect solar load sensor. With a DVOM, check voltage at terminal "A" of sensor connector. If battery voltage exists, go to next step. If battery voltage does not exist, go to step 9).
  2. Check Light Blue wire between solar load sensor connector terminal "A" and A/C-heater control module connector terminal C1 for short to battery voltage and repair. If wire is okay, go to step 8).
  3. With a DVOM, check for continuity to ground at terminal "B" of sensor connector. If continuity is indicated, go to next step. If continuity is not indicated, go to step 6).
  4. Turn ignition switch to OFF position. Reconnect solar load sensor. Turn ignition to ON position. Use incandescent shop light to shine on sun load sensor. If solar load counts on scan tool read above 250, go to next step. If counts are below 250, go to step 7).
  5. Replace sensor.
  6. Repair open in Black wire between solar sensor connector terminal "B" and A/C-heater control module connector terminal D9. If wire is okay, go to step 8).
  7. Turn ignition switch to OFF position. Reconnect sensor. Turn ignition switch to ON position. Clear A/C-heater system DTCs. See CLEARING TROUBLE CODES  under TESTING. Operate A/C-heater system. If DTC resets, go to next step. If DTC does not reset, check connections to sensor and A/C-heater control module.
  8. Replace A/C-heater control module.
  9. Using a DVOM, check voltage at terminal "A" of solar load sensor connector. If DVOM indicates between 4-6 volts, go to step 5). If DVOM does not indicate 4-6 volts, go to next step.
  10. Check for open in Light Blue wire between solar load sensor connector terminal "A" and A/C-heater control module connector terminal C1 and repair. If wire is okay, go to step 8).