Code B0185: Solar Load Sensor Circuit Low
- Turn ignition switch to OFF position. Disconnect solar load sensor. Disconnect A/C-heater control module connector. With a DVOM, check for continuity to ground at terminal C1 (Light Blue/Black wire) of A/C-heater control module connector. If continuity is indicated, go to step 3). If continuity is not indicated, go to next step.
- Reconnect sensor and A/C-heater control module connectors. Turn ignition switch to ON position. Cover solar load sensor from light. Read solar load sensor counts on scan tool. Correct reading is 10 counts or less. If sensor stays at or around 20 counts, go to step 4). If counts are other than specified, go to step 5).
- Repair short to ground in Light Blue wire between solar load sensor connector terminal "A" and A/C-heater control module connector terminal C1.
- Replace sensor.
- Clear A/C-heater system DTCs. See CLEARING TROUBLE CODES under TESTING. Operate A/C-heater system. If DTC resets, go to next step. If DTC does not reset, check connections to sensor and A/C-heater control module.
- Replace A/C-heater control module.