LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1984 >> Magnavan 6.2 J, 475/M40 >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Diagnosis & Testing >> Set/Coast Switch Test

Set/Coast Switch Test

  1. Turn ignition switch on. Place cruise control switch in "ON" position. Measure voltage at control module by probing pin "L" (circuit 84 - Dark Blue) and connecting other end of voltmeter to a good known Ground. If 12 volts are present, go to step 2). If zero voltage is present, go to step 4).
  2. Disconnect control module connector. Probe pin "L" (circuit 84) and other end of voltmeter to Ground. If voltage is zero, check circuit 84 - Dark Blue shorting to 12 volts in connector or malfunctioning control module. Repair or replace as required.
  3. If 12 volts are present, disconnect connector (C235) and measure voltage at terminal "D" (circuit 84 - Dark Blue) on switch side of connector. If voltage is zero, check for short to 12 volts in wire. Repair or replace as required. If 12 volts are present, check for short in (C235) connector. If no short, replace switch. End of test.
  4. Depress and hold in set/coast switch. Measure voltage at pin "L" (circuit 84 - Dark Blue) of control module. If 12 volts are present, switch is okay. If voltage is zero, disconnect connector (C235) and measure voltage at terminal "B" (circuit 397) on switch side of connector.
  5. If voltage is zero, go to step 7). If 12 volts are present, depress and hold in set/coast switch. Measure voltage at terminal "D" on switch side of connector. If voltage is zero, replace switch.
  6. If 12 volts are present, check terminal "D" (circuit 84) of connector (C235) to pin "L" of control module. Find open in circuit, repair and replace as required. End of test.
  7. Measure voltage at terminal "A" (circuit 39 - Pink/Black) on harness connector side. If voltage is zero, find open in circuit 39 - Pink/Black or blown fuse. Repair or replace as required.
  8. If 12 volts are present, make sure that cruise control switch is in "ON" position. If switch is on and zero volts are present at terminal "B" (circuit 397) on connector side of switch, replace switch.