EXPERTEC TSB (85-B-20)
Publication date: 1984-10-30Reference number: 85-B-20
EXPERTEC TSB
TECHNICAL SERVICE BULLETIN
FALSE SETTING - TROUBLE CODE - FEEDBACK FROM GEN. LT. CIRCUIT
Model(s): 1984 GMC S/T Truck 2.8L RPO LR2 with YF5 California Emissions
1984 GMC G Van 4.1 L, 5.0 L, 5.7L RPO LE3, LF3, LS9 with YF5 California Emissions, without Gage Package
Bulletin No.: GMC 85-B-20
Date: 10/30/1984
SERVICE INFORMATION
A false Trouble Code 42, Electronic Spark Timing (EST) may be stored in the Electronic Control Module (ECM). This condition does not cause a typical EST type condition such as "no start", "starts/will not run" or a change in RPM.
A false Trouble Code 42 can be detected in one of two ways, either the Check Engine Light is on continuously or there is no Check Engine Light on, however, a Code 42 is stored in the ECM.
This condition can be caused by an electrical feedback from the generator light circuit back to the ECM. This condition can be corrected by installing a diode jumper assembly (see Fig. No. 1), P/N 12047479, between the generator and the existing harness.
Before this diode jumper assembly is installed, it should be determined that it is a false code and not a legitimate EST problem.
Refer to the service manual for diagnosis of trouble codes.