LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1980 >> Forward Control 4.8L Eng VIN T, Standard Trans >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> ROCHESTER 1ME Single Barrel >> Overhaul >> Reassembly

ROCHESTER 1ME Single Barrel: Overhaul: Reassembly

NOTE: Use new gaskets and seals. Make sure that new gaskets fit correctly and that all holes and slots are punched through and correctly located.

To reassemble carburetor, reverse disassembly procedure noting the following:

  1. Adjust float level and metering rod before installing at horn. All other adjustments are made with carburetor assembled.
  2. Install metering rod with spring above power piston.
    Fig 1: Exploded View of Rochester Model 1ME Single Barrel Carburetor
    G09348167Courtesy of GENERAL MOTORS COMPANY
  3. Thermostatic spring in idle compensator must hold valve closed after installation. Replace unit if spring is bent or distorted. Do not attempt to straighten or adjust spring.
  4. Use two tapered head screws for mounting and locating diaphragm bracket. Install and tighten air horn screws evenly and in sequence shown in Fig 2 . 
    CAUTION: Do not use gasket between choke housing and thermostatic coil cover. Coil is grounded through cover.
    NOTE: If choke coil cover was removed, it will be necessary to install self-tapping retaining screws (supplied in service kit) to replace retainer rivets. Before installing cover, start self-tapping screws into choke coil housing, making sure they start easily and are aligned properly. Remove screws and proceed as follows:
  5. Place fast idle screw on high step of fast idle cam. Install choke coil cover, aligning notch in cover with raised boss on housing cover flange. Install self-tapping screws and tighten.
    CAUTION: Do not use a gasket between choke housing and electric coil. Coil is grounded through housing.
  6. Install vacuum diaphragm hose to diaphragm tube and connect to vacuum extension on bowl.
    NOTE: When installing carburetor on intake manifold, install insulator, then carburetor. Tighten (2) nuts to 36 in. lbs.; then tighten nuts to 18 ft. lbs.
    Fig 2: Air Horn Tightening Sequence
    G09348168Courtesy of GENERAL MOTORS COMPANY
    CARBURETOR ADJUSTMENT SPECIFICATIONS

    Application Float Level Setting Metering Rod Setting Choke Coil Lever Setting Auto. Choke Setting Choke Coil Rod Setting Vacuum Break Setting Choke Unloader Setting
    All Models 11/32" .090" .120" Index .275" .400" .520"