LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2023 >> Bronco Wildtrak, 2D Utility >> Repair and Diagnosis >> Suspension >> Suspension Control Systems >> Vehicle Dynamic Suspension >> Removal And Installation >> Vehicle Dynamics Control Module (VDM) >> Removal

Vehicle Dynamics Control Module (VDM): Removal

NOTE: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
NOTE: Removal steps in this procedure may contain installation details.
  1. Position the vehicle on a hoist. Refer to: Jacking and Lifting .
  2. NOTE: The PMI process must begin with the current VDM installed. If the current VDM does not respond to the diagnostic scan tool, the tool may prompt for As-Built Data as part of the repair.

    Using a diagnostic scan tool, begin the PMI process for the VDM following the on-screen instructions.

  3. Release the clips and remove the VDM cover.
    GFD755279Courtesy of FORD MOTOR COMPANY
  4. Disconnect the VDM electrical connector.

    1. Unlatch the VDM electrical connector.
    2. Disconnect the VDM electrical connector and position the harness aside.

    GFD755280Courtesy of FORD MOTOR COMPANY
  5. NOTE: The VDM is mounted to the RH outside frame rail.

    Remove the retainers and the VDM.

    Torque: 71 lb.in (8 Nm)

GFD755281Courtesy of FORD MOTOR COMPANY