LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2021 >> Mustang Mach 1, Automatic Trans >> Repair and Diagnosis >> Electrical >> Gauges >> Instrument Panel And Console >> Removal And Installation >> Floor Console >> Removal

Floor Console: Removal

NOTE: Removal steps in this procedure may contain installation details.

All vehicles 

  1. Release the clips and remove the floor console RH side trim panel. Use the General Equipment: Interior Trim Remover
    GFD605398Courtesy of FORD MOTOR COMPANY
  2. Release the clips and the floor console LH side trim panel. Use the General Equipment: Interior Trim Remover
    GFD605399Courtesy of FORD MOTOR COMPANY

    Vehicles without Rotary selector dial 

  3. Remove the stowage area mat.
    GFD605400Courtesy of FORD MOTOR COMPANY
  4. Remove the floor console upper bolts.

    Torque: 18 lb.in (2 Nm)

    GFD605401Courtesy of FORD MOTOR COMPANY
  5. NOTE: Automatic transmission shown, manual transmission similar.

    Starting from the front corners, carefully pry up the bezel and position it out of the way. Use the General Equipment: Interior Trim Remover

    GFD604928Courtesy of FORD MOTOR COMPANY
  6. Disconnect the electrical connector.
    GFD604929Courtesy of FORD MOTOR COMPANY

    All vehicles 

  7. Open the floor console lid.
    GFD605402Courtesy of FORD MOTOR COMPANY
  8. Remove the RH side front retainers.

    Torque: 18 lb.in (2 Nm)

    GFD605403Courtesy of FORD MOTOR COMPANY
  9. Remove the LH side front retainers.

    Torque: 18 lb.in (2 Nm)

    GFD605404Courtesy of FORD MOTOR COMPANY
  10. Release the clips, position the gear selector cover aside and remove the floor console upper trim panel.

    • Disconnect the electrical connectors. Use the General Equipment: Interior Trim Remover

    GFD605405Courtesy of FORD MOTOR COMPANY

    Vehicles with Rotary selector dial 

  11. Remove the bolts and the push pin.

    Torque: 18 lb.in (2 Nm)

    GFD605406Courtesy of FORD MOTOR COMPANY

    All vehicles 

  12. Release the clips and remove the floor console RH side bolt cover. Use the General Equipment: Interior Trim Remover
    GFD605407Courtesy of FORD MOTOR COMPANY
  13. Release the clips and the floor console LH side bolt cover. Use the General Equipment: Interior Trim Remover
    GFD605408Courtesy of FORD MOTOR COMPANY
  14. Remove the floor console stowage bin mat.
    GFD605409Courtesy of FORD MOTOR COMPANY
  15. Remove the two nuts.

    Torque: 18 lb.in (2 Nm)

    GFD605410Courtesy of FORD MOTOR COMPANY

    Vehicles without Rotary selector dial 

  16. Remove the stowage area tray.
    GFD605411Courtesy of FORD MOTOR COMPANY
  17. Remove the 2 front upper floor console bolts.

    Torque: 18 lb.in (2 Nm)

    GFD605412Courtesy of FORD MOTOR COMPANY

    All vehicles 

  18. Remove the floor console.

    1. On both sides. Release the clips.
    2. Remove the screws and position aside the parking brake boot from the console.
    3. Disconnect the electrical connectors.

GFD605413Courtesy of FORD MOTOR COMPANY