LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2019 >> Transit-150 Base, 3.2L Eng VIN V >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Electronic Engine Controls - 3.2L DURATORQ-TDCI (148KW/200PS) - Puma >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation

Powertrain Control Module (PCM): Installation

  1. Install the PCMand the bolts.

    Torque

    : 97 lb.in (11 Nm)

    GFD349619Courtesy of FORD MOTOR COMPANY
  2. Connect the PCM electrical connectors.
    GFD349618Courtesy of FORD MOTOR COMPANY
  3. Connect the transmission control module and the engine harnesses.
    GFD349617Courtesy of FORD MOTOR COMPANY
  4. Install the LH headlight. Refer to: Headlamp Assembly .
  5. NOTE: This step is only necessary when installing a new component.

    Position the hose aside, remove the oil filler cap and remove the engine appearance cover. Install the oil filler cap.

    GFD349435Courtesy of FORD MOTOR COMPANY
  6. NOTE: This step is only necessary when installing a new component.
    NOTE: The PCM is programmed with an IQA code for each fuel injector. If a new PCM is installed record the fuel injector IQA code located on top of the fuel injector.

    • Ford part number (example).

    • Fuel injector IQA code.

    GFD349620Courtesy of FORD MOTOR COMPANY
  7. NOTE: This step is only necessary when installing a new component.

    Remove the oil filler cap. Install the engine appearance cover, position the hose back and install the oil filler cap.

    GFD349435Courtesy of FORD MOTOR COMPANY
  8. NOTE: This step is only necessary when installing a new component.
    NOTE: The PCM must be programmed with the proper fuel injector IQA codes.

    • Using the scan tool, follow the on-screen instructions and program the PCM with the appropriate fuel injector IQA code for any fuel injector that was replaced.

  9. NOTE: This step is only necessary when installing a new component.
    NOTE: Vehicles without PATS may still require a parameter reset.

    Carry out the Parameter Reset procedure. Refer to: Passive Anti-Theft System (PATS) Parameter Reset .

  10. NOTE: This step is only necessary when installing a new component.

    Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.