LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2017 >> Fusion Titanium, FWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Warning Systems >> Side And Rear Vision System (Except Hybrid) >> Removal And Installation >> Side Obstacle Detection Control Module >> Removal

Side Obstacle Detection Control Module: Removal

NOTE: SODL is shown, SODR is similar.
  1. NOTE: If installing a new SODL or SODR, it is necessary to upload the module configuration information to the scan tool prior to removing the module. This information must be downloaded into the new SODL or SODR after installation.

    Using a diagnostic scan tool, begin the PMI process for the SODL or SODR following the onscreen instructions.

  2. Remove the rear bumper cover. Refer to: Rear Bumper Cover .
  3. Disconnect the electrical connector, remove the screws and the SODL.
    GFD196087Courtesy of FORD MOTOR COMPANY
  4. NOTE: Carry out this step only if installing a new SODL bracket.

    Remove the bolt, the screw and the SODL bracket.

GFD196088Courtesy of FORD MOTOR COMPANY